Researchers from China's East China Normal University (ECNU), Shanghai University, Donghua University and Soochow University have fabricated an inverted perovskite solar cell with remarkable charge transport.
They reportedly suppressed carrier recombination at the interface between the perovskite and the charge transport layer, as well as defect-assisted recombination originating from the perovskite layer. The cell has a p-i-n structure, which means the perovskite cell material is deposited onto the hole transport layer, and then coated with the electron transport layer, unlike with conventional n-i-p device architecture. Inverted perovskite solar cells typically show strong stability, but lag behind conventional devices in terms of conversion efficiency and cell performance.
The team used a molecule known as daminozide (DA) as interlayer and additive, to modify the perovskite buried interface energetics, and passivate defects at the such buried interface as well as in the perovskite bulk.
The team designed the cell with an indium tin oxide (ITO) substrate, a hole transport layer (HTL) made of poly-triarylamine (PTAA) and doped with the p-type dopant F4TCNQ and DA itself, a methylammonium lead iodide (MAPbI3) perovskite layer, a DA interlayer, an electron acceptor made of phenyl-C61-butyric acid methyl ester (PCBM), a phenyl-C61-butyric acid methyl ester (PCBM) layer, and a silver (Ag) metal contact.
The researchers explained that the dependences of the device power conversion efficiency on the DA interlayer thickness and the DA concentration were carefully evaluated, and the resulting optimal thickness and concentration were found to be 4 nm and 0.05 wt.%, respectively.
The device has a power conversion efficiency of 22.15%, an open-circuit voltage of 1.131 V, a short-circuit current of 23.36 mA cm−2, and a fill factor of 83.92%. For comparison, a reference device without the DA interlayer achieved an efficiency rating of 19.04%, an open-circuit voltage of 1.074 V, a short-circuit current of 22.33 mA cm−2, and a fill factor of 83.16%.
The researchers found that an unencapsulated device was able to maintain more than 90% of its initial efficiency after 1,400 hours of storage in ambient conditions, while the control device quickly loses approximately 80% of its initial value after only 700 hours of storage.
“This work highlights the importance of synchronous management of defects and buried interfaces, and thus provides a promising potential for further improving the efficiency and stability of planar perovskite solar cells,” the team stated.
